Shipping a car exhaust system via courier can be a challenge as it is not as simple as shipping a roll of tape via courier. In addition to the parts, there are hangers, clamps, and other hardware that all need to be removed and put back when the system is reinstalled.
Luckily, there are a few ways to make this process easier. With a few pieces of simple equipment, it is possible to send a car exhaust system for delivery without the fear of damage.
Removing the hangers
The first thing you will need is a tool for removing the hangers. A ratchet, socket, and extension is ideal for this job.
Once the hangers are removed, place them in a separate plastic bag or protective foam. This will protect them from damage during delivery, and it will also help you keep track of which hanger goes where.
Additionally, it is a good idea to use a bagging kit on the exhaust system itself. This helps to protect the system from scratches and dents.
When all of the hangers are removed, attach the clamps to the hangers. This will prevent the hangers from damaging the rest of the system. There are a number of ways to do this, but you can use zip ties, wire, or rubber bands.
Cleaning the exhaust system
At this point, it is also a good time to clean the exhaust system. Use a simple cleaning rag to remove any dirt or grime that may be on the system.
After the hangers are attached, start by placing the system in a sturdy cardboard box for sending. This helps to protect the exhaust system from damage during shipping.
Once the system is in the box, carefully place the hangers in the box. Take time to line up all of the hangers so that they are all facing the same direction.
When the hangers are in place, place a sheet of foam on top of them. This will help to prevent any damage that could occur during shipping. If the hangers are not lined up properly, it is possible that the system could be bent or damaged during the postage process.
Next, place the clamps in the box.
Placing the clamps in the box
Place the clamps in a plastic bag or box to keep them from scratching, and put them in a separate box from the system itself. The last thing you want to do is damage the clamps during transport and ruin your entire system before it even gets delivered.
Once the clamps and the hangers are in place, put the system in the box and close it up. Be sure not to over-stuff the box. This will help to prevent the system from being damaged during transport.
When the box is ready to be posted, you can start shipping.
Shipping the packaged exhaust system
Start by placing the box in the back of the truck, and then strap it down with ratchet straps. If you would like, you can also use a shipping crate used for postage. This will help to prevent the box from shifting during transport.
Next, you need to transport the exhaust system to the courier company. You can do this by either driving it to the company or by dropping it off.
If you decide to drop it off, make sure that you call ahead to make sure they are prepared to accept the package you are posting.
Sending an exhaust system for delivery can be difficult, but it is possible. It is also important to make sure that the system is packaged properly for transport and postage. This will help to ensure that the exhaust system you are sending gets delivered in the same condition that it was in when it left the shop.
If you need to send an exhaust system, visit Fast Courier today. We provide the fastest online courier quote comparison in Australia!